Independent Vehicle Design Review
No fabrication or hallway testing today
This is a self-directed technical communication and analysis activity. Do not cut, glue, build, or conduct official trials with the substitute teacher.
Instructions for the substitute teacher
- Students should work from this page for the full class.
- No technical demonstration is required.
- Do not distribute new supplies or permit cutting, hot glue, fabrication, hallway testing, or extensive rubber-band winding.
- Students may carefully inspect and measure their vehicles at their desks.
- Partners may discuss a shared vehicle, but each student submits an individual drawing, analysis, plan, and Notion section.
- Students may use existing class resources or appropriate research sources. They must record the source and explain the idea in their own words.
- Early finishers complete the extension rather than beginning construction.
Work sequence
Complete the sections below in order. Each section produces evidence required in your individual Notion entry.
1. Inspect and measure
Record overall length and width, wheel diameter, axle spacing, and one other dimension that affects performance. Note visible alignment, rubbing, loose connections, or instability.
2. Annotated technical drawing
Create or improve a top or side view with:
- important dimensions;
- labelled chassis, wheels, axles, axle supports, and rubber-band connection;
- arrows showing how motion transfers to the drive wheels;
- two callouts identifying a strength, limitation, or concern.
3. Explain the system
Explain how winding stores energy, how the drive axle turns the wheels, how friction and alignment affect performance, and why the vehicle may curve, stop early, or behave inconsistently.
4. Strengths and limitations
Record at least two of each. Support every statement with an observation, measurement, photograph, or earlier result.
5. Compare improvements
Use existing class resources, approved AI support, or another appropriate source to compare at least two possible improvements. Record the source, describe the idea in your own words, and explain whether it fits the available materials and precision goal.
6. Final improvement plan
State what will change, why it is the best next step, what evidence supports it, what will remain constant, and how you will judge whether it worked.
7. Testing procedure
Write a numbered plan including the common starting line, target distance, release without pushing, three trials, stopping-distance measurement, absolute error, and consistent data recording.
Early-finisher extension
Create a troubleshooting flowchart for one likely failure, or compare how two improvements could affect both accuracy and consistency. Use labelled diagrams or a prediction table.
Safety
- Inspect and measure at a desk.
- Do not cut, glue, fabricate, or conduct hallway trials.
- Do not wind or release a rubber band toward any person or object.
Complete Part 3 of the Notion entry.