Precision Vehicle Construction and Troubleshooting

Build the simplest complete system first. Add complexity only when evidence shows that it is needed.

Change one variable at a time

If several features change together, you will not know which decision caused the result. Make one purposeful adjustment, observe what happens, and record the evidence.

Suggested construction order

  1. Cut and reinforce the chassis.
  2. Position axle supports using measurements from the design plan.
  3. Install straight, parallel axles.
  4. Attach centred wheels and check clearance.
  5. Add the rubber-band connection and drive system.
  6. Rotate each part by hand before winding the rubber band.
  7. Conduct a short controlled functionality check.

Check before adding more parts

  • Do both axles rotate freely?
  • Are the axles parallel?
  • Do wheels clear the chassis?
  • Are wheels secure and centred?
  • Does the rubber band unwind without catching?
  • Is the chassis twisting or flexing?

Troubleshooting table

Change one important variable at a time so the result can be interpreted.

SymptomPossible causesUseful checks
Does not moveRubber band not transferring force, axle binding, wheel contact, insufficient windingRotate axle by hand; inspect band connection and wheel clearance
CurvesAxles not parallel, unequal wheels, rubbing wheel, uneven chassisMeasure axle spacing on both sides; spin each wheel separately
Wheels spin without travelLow traction, too much initial torque, unsuitable wheel surfaceReduce winding; inspect wheel contact with floor
Stops quicklyAxle friction, rubbing, misalignment, excess massLift and spin wheels; locate contact points
Is unstableNarrow track, flexible chassis, loose joint, uneven placementInspect from front and top; press gently to find movement
Results vary widelyInconsistent winding or release, loose components, changing alignmentStandardize winding and release; mark starting position; inspect after each check

Problem–cause–adjustment–result record

Observed problemLikely causeOne adjustmentResult and next step

Safety

Tools and test areas

Complete the teacher’s safety instruction before cutting or using hot glue. Release vehicles only in the designated clear area.

  • Complete teacher safety instruction before using cutting tools or hot glue.
  • Cut on the approved surface and secure material before cutting.
  • Keep fingers clear of blades and hot-glue nozzles.
  • Allow glue to cool before touching a joint.
  • Wind only enough for the permitted check.
  • Point the vehicle away from people, computers, walls, and fragile objects.
  • Retrieve it only after it stops and the path is clear.

AI-assisted troubleshooting

AI can help list possible causes or ask diagnostic questions when you provide specific observations. Use the AI guide, then verify every suggestion through inspection or a controlled physical test.